Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T23:52:44.167Z Has data issue: false hasContentIssue false

Interpretation of Aerogel Shrinkage During Drying.

Published online by Cambridge University Press:  25 February 2011

Bharath Rangarajan
Affiliation:
Department of Chemical Engineering, Michigan State University, East Lansing, MI 48824, USA.
Carl T. Lira
Affiliation:
Department of Chemical Engineering, Michigan State University, East Lansing, MI 48824, USA.
Get access

Abstract

A variety of silica aerogels have been prepared by the hydrolysis of TEOS, and dried using supercritical CO2. The shrinkage which occurs during the drying process is dependent on the gel formulation and the extent of aging of the gels in their pore liquor. Such aging normally results in an increased density, modulus and pore size of wet gels. Upon drying the corresponding aerogels show the opposite behavior for modulus and density, which decrease with the extent of aging. Both drying and aging shrinkage were not observed for base-catalyzed gels, and were very small for HF-catalyzed gels. The use of formamide resulted in reduced drying shrinkage and a slightly larger amount of syneresis. Drying shrinkage is associated with the presence of micropores. Shrinkage during drying has been observed using a high pressure view cell and it was found that most of the shrinkage occurred during depressurization. An explanation consistent with the above is proposed.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable