Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-15T23:54:16.317Z Has data issue: false hasContentIssue false

Investigation on Ultra-high Density and High Speed Non-volatile Phase Change Random Access Memory (PCRAM) by Material Engineering

Published online by Cambridge University Press:  01 February 2011

E.G. Yeo
Affiliation:
YEO_ENG_GUAN@dsi.a-star.edu.sg, Data Storage Institute, Optical Materials and Systems, DSI Building, 5 Engineering Drive 1, Singapore, Singapore, 117608, Singapore
L.P Shi
Affiliation:
Shi_Luping@dsi.a-star.edu.sg, Data Storage Institute, 5 Engineering Drive 1, Singapore, Singapore, 117608, Singapore
R Zhao
Affiliation:
Zhao_rong@dsi.a-star.edu.sg, Data Storage Institute, 5 Engineering Drive 1, Singapore, Singapore, 117608, Singapore
T.C. Chong
Affiliation:
Chong_Tow_Chong@dsi.a-star.edu.sg, Data Storage Institute, 5 Engineering Drive 1, Singapore, Singapore, 117608, Singapore
Get access

Abstract

In this paper, ultra-high memory density and high speed non-volatile phase change random access memory (PCRAM) was investigated by material engineering. The melting point, crystallization point and activation energy of crystallization of the Bismuth (Bi) doped Germanium-Antimony-Tellurium (GeSbTe) compound was measured using differential scanning calorimetry (DSC) and compared to other GeSbTe ternary compounds. It was observed that the melting temperature of Bi-doped GeSbTe was lower than that of GeSbTe. On the other hand, its activation barrier was found to be reduced, which in turn increased the speed of crystallization of Bi-doped GeSbTe. Bi-doped GeSbTe was then used as a phase change material in the fabrication of PCRAM devices. The properties of PCRAM fabricated using this material were then compared to those using GeSbTe, with emphasis on the programming current required. The results obtained revealed that lower programming current of up to 40% has been achieved for PCRAM with Bi-doped GeSbTe compared to those with other GeSbTe compounds. Bi-doped GeSbTe also has low RESET current and fast speed of crystallization with scaling, making it a suitable material for high speed, ultra-high density PCRAM fabrication in the future.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable