Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T07:35:16.260Z Has data issue: false hasContentIssue false

Ion and Electron Beam Processing of Condensed Molecular Solids to Form Thin Films

Published online by Cambridge University Press:  25 February 2011

M. W. Ruckman
Affiliation:
Physics Department, Brookhaven National Laboratory, Upton, New York 11973
J. K. Mowlem
Affiliation:
The State University of New York at Stony Brook, Department of Chemistry, Stony Brook, New York 11794
J. F. Moore
Affiliation:
The State University of New York at Stony Brook, Department of Chemistry, Stony Brook, New York 11794
D. R. Strongin
Affiliation:
The State University of New York at Stony Brook, Department of Chemistry, Stony Brook, New York 11794
M. Strongin
Affiliation:
Physics Department, Brookhaven National Laboratory, Upton, New York 11973
Get access

Abstract

Electron and ion beams can be used to deposit thin films and etch surfaces using gas phase precursors. However, the generation of undesirable gas phase products and the diffusion of the reactive species beyond the region irradiated by the electron or ion beam can limit selectivity. Tn this paper, the feasibility of processing condensed precursors such as diborane, tri-methyl aluminum, ammonia and water at 78 K with low energy (100–1000 eV) electron and ion beams (Ar+, N2 + and H2 +) ranging in current density from 50 nA to several μ a per cm2 is examined. It was found that boron, boron nitride and stoichiometric aluminum oxide films could be deposited from the condensed volatile species using charged particle beams and some of the physical and chemical aspects and limitations of this new technique are discussed.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable