Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T08:31:13.381Z Has data issue: false hasContentIssue false

Ion Beam Machining of Micromechanical Structures

Published online by Cambridge University Press:  25 February 2011

S. T. Davies
Affiliation:
Microengineering and Metrology Centre, Department of Engineering, University of Warwick, Coventry, CV4 7AL UK
D. K. Bowen
Affiliation:
Microengineering and Metrology Centre, Department of Engineering, University of Warwick, Coventry, CV4 7AL UK
Get access

Abstract

The needs of high precision engineering currently call for dimensional tolerances of the order of 0.1μm and surface roughness of order 0.01μm, often in hard, brittle materials or materials of relatively poor machinability. The development of argon ion beam machining for milling, drilling and turning or lathing is reported as a means of satisfying these requirements. Highly controllable material removal is achieved for the fabrication of micromechanical structures, profiling of surfaces and fine surface finishing. Surface evolution at submicron precision is demonstrated, with particular reference to the production of both circular and non-circular sections in an “ion beam lathe”.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable