Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T22:43:50.503Z Has data issue: false hasContentIssue false

Ir Thin Films for PZT Capacitors Prepared by MOCVD Using a New Ir Precursor

Published online by Cambridge University Press:  01 February 2011

H. Fujisawa
Affiliation:
Department of Electrical Engineering and Computer Sciences, Graduate School of Engineering, Himeji Institute of Technology, 2167 Shosha, Himeji, Hyogo 671–2201, Japan
S. Watari
Affiliation:
Department of Electrical Engineering and Computer Sciences, Graduate School of Engineering, Himeji Institute of Technology, 2167 Shosha, Himeji, Hyogo 671–2201, Japan
M. Shimizu
Affiliation:
Department of Electrical Engineering and Computer Sciences, Graduate School of Engineering, Himeji Institute of Technology, 2167 Shosha, Himeji, Hyogo 671–2201, Japan
H. Niu
Affiliation:
Department of Electrical Engineering and Computer Sciences, Graduate School of Engineering, Himeji Institute of Technology, 2167 Shosha, Himeji, Hyogo 671–2201, Japan
N. Oshima
Affiliation:
Tokyo Research Center, TOSOH Corporation, 2743–1, Hyakawa, Ayase, Kanagawa 252–1123, Japan
Get access

Abstract

Preparation of Ir thin films for PZT capacitors by MOCVD using a new liquid Ir precursor, Ir(EtCp)(CHD) was investigated. Ir thin films with a highly reflecting surface and (111)-orientation were successfully obtained at 230–400 C. When Ir(EtCp)(CHD) was used, shorter incubation time (20min at 230°C and not observed above 240°C) and higher nucleation density (300–400mm-2 at 250–300°C) were observed because of its lower decomposition temperature (300°C) than that of previously reported liquid precursor, Ir(EtCp)(COD). Resistivity of 100nm-thick Ir films grown at 250–350°C were less than 20μΩ·cm. PZT capacitors with top and bottom electrodes prepared using Ir(EtCp)(CHD) showed D-E hysteresis loop with Pr of 15μC/cm and Ec of 60kV/cm. No degradation of switching up to 10 switching cycles by bipolar pulses of ±231kV/cm (±3V) and 500kHz.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable