Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-15T14:54:39.733Z Has data issue: false hasContentIssue false

Longevity of Plutonium 238 Heat Sources

Published online by Cambridge University Press:  28 May 2012

Roberta N. Mulford
Affiliation:
Los Alamos National Laboratory, Los Alamos, NM 87545, USA
Paul D. Richardson
Affiliation:
Los Alamos National Laboratory, Los Alamos, NM 87545, USA
Joseph Hickey
Affiliation:
Los Alamos National Laboratory, Los Alamos, NM 87545, USA
Rene Chavarria
Affiliation:
Los Alamos National Laboratory, Los Alamos, NM 87545, USA
Get access

Abstract

Plutonium oxide heat sources are used to power space missions. The heat produced by alpha decay of the 238 isotope of Pu is converted to electricity in a thermopile, providing electricity during a substantial fraction of the 88 year half-life of the isotope. Decay of the Pu produces helium and uranium, and a fraction of the evolved helium is captured in the oxide matrix. All of the helium produced in decay can in principle be contained in the oxide lattice, where it occupies the tetrahedral sites. Some helium diffuses out at a rate that is somewhat dependent on the form and morphology of the fuel. Rates have previously been measured for oxide aged about 1 year. Current measurements on sealed heat sources as old as 34 years indicate that the rate of diffusion has changed only slightly over time. Possible mechanisms for helium release include bubble diffusion, point defect migration, agglomeration and movement of He at grain boundaries, and volume diffusion through the lattice sites. We observe primarily diffusion from site to site within the lattice, with an activation energy of 18.7 kcal/mole, independent of point defect movement, despite the rising concentration of helium in the lattice over time and the accumulation of radiation damage within the lattice. Because of the slow diffusion of helium from the fuel to the headspace, heat sources are anticipated to be stable over a long lifetime.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2012

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable