Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T18:09:25.486Z Has data issue: false hasContentIssue false

Low-Temperature Mechanical Alloying Of Cu-Fe and Cu-Ta Powders

Published online by Cambridge University Press:  10 February 2011

J.-H. He
Affiliation:
Materials Science and Engineering Program, Department of Mechanical Engineering, Louisiana State University, Baton Rouge, LA 70803, USA
E. Ma
Affiliation:
Materials Science and Engineering Program, Department of Mechanical Engineering, Louisiana State University, Baton Rouge, LA 70803, USA
Get access

Abstract

A model analysis is presented which explains ball-milling induced alloying in positive-heatof- mixing systems in terms of a dynamic balance between externally forced mixing and thermal phase decomposition mediated by deformation-enhanced population of defects. The possibility of eliminating the thermal decomposition to force single phase formation is examined by milling Cu- Fe and Cu-Ta powder mixtures at the liquid nitrogen temperature (LN2T). Over a range of compositions for Cu-Fe and almost the entire composition range for Cu-Ta, the two-phase region observed for room-temperature (RT) milling persisted after cryomilling. The moderate temperature dependence of milling-induced alloying is interpreted by analyzing the dynamics of the generation and annihilation of the nonequilibrium vacancies during deformation and impacts in a SPEX mill.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable