Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T06:08:55.077Z Has data issue: false hasContentIssue false

Magnetron Dry Etching for Photonic Device Fabrication

Published online by Cambridge University Press:  22 February 2011

H. E. G. Arnot
Affiliation:
Paul Scherrer Institute Zürich, Badenerstrasse 569, CH-8048 Zürich, Switzerland
H. P. Zappe
Affiliation:
Paul Scherrer Institute Zürich, Badenerstrasse 569, CH-8048 Zürich, Switzerland
J. E. Epler
Affiliation:
Paul Scherrer Institute Zürich, Badenerstrasse 569, CH-8048 Zürich, Switzerland
B. Graf
Affiliation:
Paul Scherrer Institute Zürich, Badenerstrasse 569, CH-8048 Zürich, Switzerland
R. Widmer
Affiliation:
Paul Scherrer Institute Zürich, Badenerstrasse 569, CH-8048 Zürich, Switzerland
H. W. Lehmann
Affiliation:
Paul Scherrer Institute Zürich, Badenerstrasse 569, CH-8048 Zürich, Switzerland
Get access

Abstract

Magnetron dry etching using SiCl4, combined with a smooth reflowed photoresist masking technique has been used to fabricate GaAs/AlGaAs ridge waveguides. The effect of pressure, flowrate and power on etch rate and sidewall smoothness has been studied. Waveguides fabricated using optimum parameters exhibited optical losses lower than those achievable using wet etching. This process was further used in the fabrication of Fabry Perot ridge lasers, detectors and phase modulators.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable