Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-16T22:27:23.361Z Has data issue: false hasContentIssue false

Measurement of Low-k Polymerimetal Interfacial Toughness Using 4-point Bending Method

Published online by Cambridge University Press:  15 February 2011

Qing Ma
Affiliation:
Intel Corporation, Santa Clara, CA 95052
Chuanbin Pan
Affiliation:
Intel Corporation, Santa Clara, CA 95052
Harry Fujimoto
Affiliation:
Intel Corporation, Santa Clara, CA 95052
Baylor Triplett
Affiliation:
Intel Corporation, Santa Clara, CA 95052
Peter Coon
Affiliation:
Intel Corporation, Santa Clara, CA 95052
Chien Chiang
Affiliation:
Intel Corporation, Santa Clara, CA 95052
Get access

Abstract

Four-point bending method offers significant advantages over more traditional techniques in measuring adhesion properties of thin polymer films. The former utilizes sandwich structure beams where the polymer film and the interface of interest are placed at the center of two elastic bulks. Such confined geometry closely resembles applications where polymer films are used as dielectric layers in IC interconnect technology. In this work, the bonding between a poly(arylene ether) (PAE) based polymer film and an Al film was studied. Ti layers of several different thickness were used as adhesion promoter. The sandwich samples were made by bonding bulk wafers using an epoxy. Fracture energies were seen to increase with the thickness of the Ti layer. Effects of heat treatment were also studied.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable