Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-18T05:00:46.419Z Has data issue: false hasContentIssue false

Measurement of Polymer-Polymer Adhesion in Thin Multi-Layer Systems by Means of Micro-Scratch Probing

Published online by Cambridge University Press:  17 March 2011

Y. S. Garif
Affiliation:
Dept. of Chemical Engineering and Materials Science, University of Minnesota Minneapolis, MN 55455, U.S.A.
W. W. Gerberich
Affiliation:
Dept. of Chemical Engineering and Materials Science, University of Minnesota Minneapolis, MN 55455, U.S.A.
C. W. Macosko
Affiliation:
Dept. of Chemical Engineering and Materials Science, University of Minnesota Minneapolis, MN 55455, U.S.A.
A. V. Pocius
Affiliation:
3M Company, Adhesive Technologies Center St. Paul, MN 55144, U.S.A.
Get access

Abstract

A novel technique called Cross-Sectional Scratch (CSS) has been established. The technique employs a sliding contact of an indenter tip across a polymer stack cross-section. The main advantage of the technique is that it allows to measure/quantify interfacial adhesion in multilayer polymer films that are only a few microns thick. CSS has successfully tested both glassy/glassy and glassy/soft polymer interfaces. Thus, PS/PE, PET/PE, PS/PMMA and PVdF/PMMA co-extruded films were chosen as sample systems and tested at room temperature. It was found that indenter speed has a strong effect on the magnitude of the adhesion energy measured. The dependence has a power law form with indices ∼ 0.1-0.2. More viscoelastic systems have higher power law index, a measure of rate sensitivity.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable