Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T22:26:18.936Z Has data issue: false hasContentIssue false

Mechanical Properties of Ion-Implanted Thin Films and Interfaces

Published online by Cambridge University Press:  15 February 2011

G. L. Miller
Affiliation:
Bell Laboratories, 600 Mountain Avenue, Murray Hill, New Jersey USA
M. Soni
Affiliation:
Bell Laboratories, 600 Mountain Avenue, Murray Hill, New Jersey USA
M. McDonald
Affiliation:
Bell Laboratories, 600 Mountain Avenue, Murray Hill, New Jersey USA
E. N. Kaufmann
Affiliation:
Bell Laboratories, 600 Mountain Avenue, Murray Hill, New Jersey USA
R. L. Fenstermacher
Affiliation:
Drew University, Madison, New Jersey USA
Get access

Abstract

One of the areas of interest in the ion-beam modification of materials is that of alteration of specifically mechanical properties. To this end a method has been developed allowing in situ investigation of the stress, Young's modulus and mechanical hysteresis of small samples during and following ion-implantation. The samples are typically in the form of ~ 2 mm ⨉ 2 mm squares a few thousand angstroms thick, deposited on a ~ 50µ thick metal support, and forming a mechanical marginal oscillator. The measurement is carried out by flexing the samples at ~ 500 Hz under a servo-stabilized sinusoidal strain with a peak value in the range 0 to ~ 10−3. The accuracy of the method is typically ~ 1% or better for the measured quantities.

Results are presented showing strain dependent (nonlinear) mechanical effects, thermal annealing effects, ion implantation of boron into copper and ion-beam mixing of copper films on aluminum substrates.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1982

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable