Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-18T03:46:53.065Z Has data issue: false hasContentIssue false

Mechanical Properties of Soluble Polymer/Silica Gel Hybrids

Published online by Cambridge University Press:  10 February 2011

L. C. Klein
Affiliation:
Rutgers University, Ceramic & Materials Engineering, 607 Taylor Road, Piscataway, NJ 08854-8065, licklein@rci.rutgers.edu.
J. Van Wert
Affiliation:
Comell University, Geology Department, Ithaca, NY 14853
C. L. Beaudry
Affiliation:
Komatsu Silicon America, 1400 NE 48th St., Hillsboro, OR 97124
Get access

Abstract

Strengths have been measured for silica gels prepared with poly(ethylene oxide) (PEO) and poly(vinyl acetate) (PVAc). The modulus of rupture was determined using standard three-point bending in a mechanical tester. The samples were prepared by mixing tetraethylorthosilicate with the polymers dissolved in water (PEO) or water/ethanol(PVAc). Molecular weights between 200 and 3400 were used for PEO. Substitutions of the polymer for silica represented between 5 and 25% on a weight basis. In these systems, the interactions between the polymer and the silica network are largely through hydrogen bonding, between ether oxygens in PEO and silanols and between hydroxyls in PVAc and silanols. The extent of the bonding increases with increasing aging time, as indicated by an almost linear increase in the modulus of rupture. The increase for PEO was greater than for PVAc. Among PEO samples, the strengths were higher for higher molecular weights at the same weight fraction.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable