Hostname: page-component-7b7567c8c-slfcl Total loading time: 0 Render date: 2026-11-19T15:37:02.159Z Has data issue: false hasContentIssue false

Melt Infiltration Processing of Foams Using Glass-Forming Alloys

Published online by Cambridge University Press:  11 February 2011

C. San Marchi
Affiliation:
Department of Materials Science & Engineering, Northwestern University, Evanston, IL 60208
A. Brothers
Affiliation:
Department of Materials Science & Engineering, Northwestern University, Evanston, IL 60208
D. C. Dunand
Affiliation:
Department of Materials Science & Engineering, Northwestern University, Evanston, IL 60208
Get access

Abstract

Processing of foams from bulk metallic glass (BMG) alloys, using melt infiltration techniques, is reported for the first time. Foaming methods based on infiltration of two types of pattern materials are described: investment of a continuous refractory yielding very low relative density structures (5% dense relative to the BMG), and investment of a discontinuous refractory pellet bed yielding higher relative density (50–60% dense relative to the BMG). Both methods are capable of producing foam structures; however high surface area and diminished thermal conductivity, especially in lower density structures, make vitrification of the alloy difficult.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable