Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-18T08:32:18.364Z Has data issue: false hasContentIssue false

Metallic Impurities and Dopant Cross-Contamination Effects in Ion Implanted Surfaces

Published online by Cambridge University Press:  25 February 2011

L. A. Larson
Affiliation:
National Semiconductor Corp. 2900 Semiconductor Drive, Santa Clara, CA 95051
M. I. Current
Affiliation:
Xerox-Palo Alto Research Center, 3333 Coyote Hill Road, Palo Alto, CA 94304
Get access

Abstract

Contamination of implanted surfaces by metals and dopants is a significant limitation to the use of high-dose implantation for semiconductor IC fabrication. RBS, SIMS, SRP, chemical etching and IC device parameter measurements have been used to characterize contaminated surfaces implanted with modern, production-type implanters. Levels of dopant cross -contamination of the order of 10% of the primary dose have been observed. A systematic study of the effects of As, P, B and Sb implanted Si has shown measurable effects on diffusion profiles and junction depths at contamination levels as low as 0.01% of the primary dose. These effects are particularly serious for fast-diffusing contaminants in slow-diffusing primary dopants (such as P contamination in As implants). Evidence has been found for both sputtering and ‘vaporization’ mechanisms for transfer of contaminants from implanter surfaces to the wafer target. The effectiveness of machine design choices and process procedures (such as wafer clamp design, post-implant chemical cleans, and the use of screen oxides) in minimizing the effects of contamination are discussed.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable