Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T23:49:59.605Z Has data issue: false hasContentIssue false

A Method for Analyzing the Critical Adhesion Energy of Thin Film Coatings

Published online by Cambridge University Press:  21 February 2011

Frederick J. McGarry
Affiliation:
Massachusetts Institute of Technology, Dept. of Materials Science and Engineering, Cambridge, MA 02139
Edward O. Shaffer II
Affiliation:
Massachusetts Institute of Technology, Dept. of Materials Science and Engineering, Cambridge, MA 02139
Get access

Abstract

The edge delamination test (EDT) measures the energy required to cause a thin film, under biaxial tensile stress, to debond from a rigid substrate. Circular holes are etched through the films and if the stress is large enough, stable debond rings grow radially around the holes. A finite element analysis is used to find the applied strain-energy release rate as a function of debond crack length, hole radius and side-wall angle. However, the analysis may not be widely available, so, we present tables of reduced debond energy val ues, Gr, to facilitate the use of the EDT. With observed EDT results, Gr is extrapolated from the tables and then the critical debond energy is calculated by multiplying Gr by the maximum strain energy. Also, we have fit Gr with a semi-empirical equation, which is in good agreement over a broad range of geometries.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable