Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T11:40:57.910Z Has data issue: false hasContentIssue false

Microstructure and Mechanical Properties of Ni3Al-Ai2O3 Composites Produced by Hot Extrusion

Published online by Cambridge University Press:  21 February 2011

C. G. McKamey
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831
E. H. Lee
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831
Get access

Abstract

Hot extrusion of premixed charges of 10–20 vol% chopped A12O fiber and Ni3Al powder has resulted in composite alloys of near theoretical density. In tensile tests at room temperature, density-compensated yield strengths of some of these composite alloys are as good or better than those of as-cast Ni3Al without reinforcement; however strengths at 1000°C in vacuum are lower. The low strength at 1000°C and fine grain size (2–3/μm) suggest the presence of superplastic behavior and the accompanying diffusional creep and grain boundary sliding. This presentation discusses our findings to date and includes microstructural studies and tensile properties, both at room temperature in air and 1000°C in vacuum.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable