Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T19:50:59.926Z Has data issue: false hasContentIssue false

Microstructure of Rapidly Solidified Cu-Fe Alloys

Published online by Cambridge University Press:  21 February 2011

Uwe Köster
Affiliation:
Department of Chemical Engineering, University of Dortmund, D-4600 Dortmund 50, F.R.Germany
Christoph Caesar
Affiliation:
Department of Chemical Engineering, University of Dortmund, D-4600 Dortmund 50, F.R.Germany
Get access

Abstract

Rapidly solidified ribbons of Cu-Fe alloys with iron contents up to 20 at.−% have been prepared by melt-spinning. Optical and electron microscopy as well as x-ray and electron diffraction techniques were used to characterize quantitatively the microstructure, i.e., grain size and shape, solubility of iron, lattice parameter, volume fraction and distribution of precipitated iron-particles, etc.

Whereas the free surfaces of melt-spun Cu-Fe ribbons have been found to be very smooth, the contact surfaces usually consist of isolated areas of good thermal contact with small equiaxed grains separated by bands without contact during casting and therefore poor heat transfer. The cross sections of the ribbons generally exhibit a strong anisotropy in their microstructure: very fine crystals adjacent to the contact surface develop into narrow columnar grains, generally significantly elongated and extending across the whole section. The average columnar width of the grains has been found to decrease significantly with increasing iron content. Precipitation of iron not only depends on the iron content but also on the distance from the contact surface.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1984

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable