Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-16T18:15:31.134Z Has data issue: false hasContentIssue false

Microstructure/Property Studies Supporting Development of Low Cost Processes for TiAl Automotive Valves

Published online by Cambridge University Press:  22 February 2011

P. E. Jones
Affiliation:
University of Dayton, Graduate Materials Engineering, Dayton, OH 45469–0240, USA
W. J. Porter III
Affiliation:
University of Dayton, Graduate Materials Engineering, Dayton, OH 45469–0240, USA
M. M. Keller
Affiliation:
University of Dayton, Graduate Materials Engineering, Dayton, OH 45469–0240, USA
D. Eylon
Affiliation:
University of Dayton, Graduate Materials Engineering, Dayton, OH 45469–0240, USA
Get access

Abstract

Lightweight gamma titanium aluminide automotive valves may significantly improve engine performance and fuel economy. However, low cost mass production processes must be developed to realize these gains. Permanent mold casting processes and low cost heat treatments are being developed to enable commercial introduction of TiAl automotive valves. Microstructural development, tensile, creep, and high cycle fatigue properties of permanent mold Ti-47Al-2Nb-1.75Cr (at%) castings are compared with investment castings of similar size. A recommendation is made to use as-HIP castings for components not designed to damage tolerant criteria. This work was performed as part of a vertically integrated team effort to transfer aerospace TiAl technology to the automotive market.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable