Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T07:58:15.938Z Has data issue: false hasContentIssue false

Microstructures of Rapidly Solidified Titanium-Eutectoid Former Alloys

Published online by Cambridge University Press:  21 February 2011

S. Krishnamurthy
Affiliation:
Aair Force Wright Aeronautical Laboratories, Materials Laboratory, tructural Metals Branch, Wright-Patterson Air Force Base, OH 45433;
R. G. Vogt
Affiliation:
Aair Force Wright Aeronautical Laboratories, Materials Laboratory, tructural Metals Branch, Wright-Patterson Air Force Base, OH 45433;
D. Eylon
Affiliation:
Metcut-Materials Research Group, P.O. Box 33511, Wright-Patterson Air Force Base, OH 45433
F. H. Froes
Affiliation:
Aair Force Wright Aeronautical Laboratories, Materials Laboratory, tructural Metals Branch, Wright-Patterson Air Force Base, OH 45433;
Get access

Abstract

Titanium-base binary alloys containing eutectoid forming additions such as Fe, Si, W, and Cr were rapidly solidified by pendant drop melt extraction, melt spinning, and “hammer and anvil” techniques. The materials obtained were fibers, ribbons, and splats, respectively. The microstructures of these rapidly solidified materials were analyzed by optical microscopy, SEM, and TEM. The fibers showed fine microstructures near the quenched side, but less homogeneous and coarser microstructures were observed away from this side. Similar variations were observed between the edge and the center of splats. The results of this microstructural characterization are discussed, and a comparison made between microstructures obtained by the different rapid solidification methods used.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1984

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable