Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T11:34:08.864Z Has data issue: false hasContentIssue false

MOCVD of Field Emission Phosphors using a Liquid Delivery System

Published online by Cambridge University Press:  10 February 2011

T. S. Moss
Affiliation:
M.S. E549, Los Alamos National Laboratory, Los Alamos, NM 87545
B. F. Espinoza
Affiliation:
M.S. E549, Los Alamos National Laboratory, Los Alamos, NM 87545
K. V. Salazar
Affiliation:
M.S. E549, Los Alamos National Laboratory, Los Alamos, NM 87545
R. C. Dye
Affiliation:
M.S. E549, Los Alamos National Laboratory, Los Alamos, NM 87545
Get access

Abstract

Thin film phosphors for field emission displays show the potential to overcome the life-limiting problems that traditional powders face because of their high surface areas. By depositing a fully dense thin film, the surface area can be dramatically reduced, while the electrical and thermal conductivity is increased. Metal organic chemical vapor deposition offers the ability to deposit high quality, dense films that are crystalline-as-deposited and at temperatures low enough to allow for inexpensive glass. Deposition has been produced from mixtures of Y(tmhd)3, TEOS, Tb(tmhd)3, and O2 using a liquid delivery system. Coatings were shown to be composed of Y, Si, and Tb by x-ray fluorescence, but x-ray diffraction did not show any crystallinity. Excitation using radioluminescence produced a peak in the visible green at approximately 540 nm, indicative of the excitation of Tb3+. The morphology of the deposition was smooth, with surface features on the order of one micron and below. Some limited microcracking was also observed in the morphology because of the thermal expansion mismatch.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable