Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T13:36:15.618Z Has data issue: false hasContentIssue false

Nanomechanical Characterization on Zinc and Tin Oxides Nanobelts

Published online by Cambridge University Press:  11 February 2011

Minhua Zhao
Affiliation:
Department of Mechanical Engineering, Univ. of Pittsburgh, Pittsburgh, PA 15261
Scott Mao
Affiliation:
Department of Mechanical Engineering, Univ. of Pittsburgh, Pittsburgh, PA 15261
Zhong Lin Wang
Affiliation:
School of Materials Sci. & Engr., George Institute of Technology, Atlanta, GA 30332–0245
Fengting Xu
Affiliation:
Department of Materials Sci. & Engr., Univ. of Pittsburgh, Pittsburgh, PA 15261
John A Barnard
Affiliation:
Department of Materials Sci. & Engr., Univ. of Pittsburgh, Pittsburgh, PA 15261
Get access

Abstract

Nanobelts are a group of materials that have a rectangle-like cross section with typical widths of several hundred nanometers, width-to-thickness ratios of 5 to 10, and lengths of hundreds of micron meters. In this paper, nanoindentations were made on individual ZnO, SnO2 nanobelts and (0001) bulk ZnO by using AFM and Hysitron Triboscope indenters. It was shown that the indentation size effect was still obvious for the indentation depth under 50 nm. It is also demonstrated that nanomaching is possible on nanobelt using AFM tip.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable