Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T02:10:12.580Z Has data issue: false hasContentIssue false

Nitric Oxide Rapid Thermal Nitridation of Thin Gate Oxides

Published online by Cambridge University Press:  10 February 2011

J. Kuehne
Affiliation:
Semi conductor Process & Device Center, Texas Instruments, Inc. Dallas, TX 75265
S. Hattangady
Affiliation:
Semi conductor Process & Device Center, Texas Instruments, Inc. Dallas, TX 75265
J. Piccirillo
Affiliation:
RTP Division, Applied Materials, Inc. Dallas, TX 75082
G. C. Xing
Affiliation:
RTP Division, Applied Materials, Inc., Santa Clara, CA 95054
G. E. Miner
Affiliation:
RTP Division, Applied Materials, Inc., Santa Clara, CA 95054
D. Lopes
Affiliation:
RTP Division, Applied Materials, Inc., Santa Clara, CA 95054
Get access

Abstract

Nitric oxide rapid thermal nitridation of thin gate oxides was investigated. Oxides from 25 to 55 Å were grown in O2 and subsequently nitrided in a nitric oxide (NO) ambient using an Applied Materials RTP Centura chamber. Nitrogen incorporation and film thickness growth during NO nitridation were evaluated. Peak nitrogen incorporation was most strongly influenced by temperature and time, with moderate influence by initial oxide thickness, and no significant influence due to NO flow rate. Peak nitrogen concentrations ranged from 1 to 9 atomic percent as characterized by Secondary Ion Mass Spectrometry (SIMS) analysis. Oxide growth during nitridation ranged from 2 Å to 11 Å with no degradation in uniformity. These data were used in the design of two 40 Å oxynitride processes incorporating 2 and 4 peak atomic percent nitrogen. High quality MOS capacitors were demonstrated with these dielectrics. Performance was compared against a baseline furnace process as well as non-nitrided RTO. Throughout this work, the chamber integrity was monitored using visual inspection, minority carrier lifetime (MCLT) and surface photovoltage (SPV). No contamination, corrosion or other degradation of the process chamber was observed in over 6 months' operation with over 700 NO processes completed. The controllability, uniformity and high nitrogen incorporation of rapid thermal NO nitridation make it an attractive process for deep sub-micron gate insulators.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable