Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T06:31:07.320Z Has data issue: false hasContentIssue false

Non-Destructive Evaluation of Strains and Voiding in Passivated copper Metallizations

Published online by Cambridge University Press:  21 February 2011

Richard P. Vinci
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, CA 94305
Thomas N. Marieb
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, CA 94305
John C. Bravman
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, CA 94305
Get access

Abstract

Stress induced voiding in passivated Cu lines was investigated by x-ray strain analysis and in-situ high voltage scanning electron microscope (HVSEM) techniques. Cu lines on a Ta underlayer and Cu lines on an Al underlayer were patterned by a trilayer liftoff technique and passivated with Si3N4. For direct observation of stress voiding, specimens were heated to 350°C in the HVSEM and then cooled and held at 150°C. Identical samples were subjected to the same thermal cycle for strain state determination using x-ray techniques. The hydrostatic stress state at each temperature was calculated from the measured strains. Few initial voids were observed after passivation in either sample. After heating to 350°C and cooling to the dwell temperature, no new voiding was seen in the Ta/Cu lines. Measured hydrostatic strains were half those measured in the Al/Cu lines. Heavy voiding was observed in the Al/Cu lines after cooling to the dwell temperature.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable