Hostname: page-component-7b7567c8c-2jgqx Total loading time: 0 Render date: 2026-11-19T11:25:15.650Z Has data issue: false hasContentIssue false

Novel High-Q Suspended Inductors on Alumina Ceramic Substrates

Published online by Cambridge University Press:  01 February 2011

Lisa Woodward
Affiliation:
Gennum Corporation, 970 Fraser Drive, Burlington, Ontario L7L 5P5, CanadaDept. of Electrical and Computer Engineering, University of Waterloo, 200 University Ave. W., Waterloo, Ontario N2L 3G1, Canada
Paul Woo
Affiliation:
Gennum Corporation, 970 Fraser Drive, Burlington, Ontario L7L 5P5, Canada
Mircea Capanu
Affiliation:
Gennum Corporation, 970 Fraser Drive, Burlington, Ontario L7L 5P5, Canada
Ivo Koutsaroff
Affiliation:
Gennum Corporation, 970 Fraser Drive, Burlington, Ontario L7L 5P5, Canada
C. R. Selvakumar
Affiliation:
Dept. of Electrical and Computer Engineering, University of Waterloo, 200 University Ave. W., Waterloo, Ontario N2L 3G1, Canada
Andrew Cervin-Lawry
Affiliation:
Gennum Corporation, 970 Fraser Drive, Burlington, Ontario L7L 5P5, Canada
Get access

Abstract

The growth of the wireless industry over the past ten years has created a need for good quality passive components, and in particular high Q factor inductors. There has been a large amount of work aimed at improving the quality factors of inductors on both silicon and ceramic/insulating substrates. KAIST and other research groups have explored a MEMS technique, releasing the inductor coil to create an air gap between the coil and underpass, on silicon [1]. Typically the inductor coil has been separated by a 50 to 100μm air gap and has required special processing such as a dual exposure photoresist mold [1]. In the present work, suspended inductor coils have been fabricated and characterized on an alumina ceramic substrate [2]. The gap used was only 1μm and this was enough to increase the self-resonance frequency by up to 4GHz after release. The inductor coils were created in 6–10μm thick electroplated gold and the underpass in an aluminum layer. A sacrificial LPCVD oxide layer was used as the released dielectric. In the present study a range of inductance from 1 to 30nH was explored before and after release. The Q factors achieved in this work range from 40 to 70 in the 2 to 10 GHz range, which are some of the best Q factors reported for planar inductors (see Table I). In addition, since the architecture allowed the use of three metal layers, released transformers were also fabricated. They showed promising high frequency performance, which also will be presented. Minimum insertion loss better then –2dB was achieved between 10–12 GHz. The above described process is simple, precise, and manufacturable with the ability to extend the useful range of inductors to higher frequencies (1–10 GHz).

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable