Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T09:43:39.807Z Has data issue: false hasContentIssue false

Ohmic Contact Formation to Doped GaN

Published online by Cambridge University Press:  21 February 2011

L. L. Smith
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907
M. D. Bremser
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907
E. P. Carlson
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907
T. W. Weeks Jr.
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907
Y. Huang
Affiliation:
Center for Solid State Science, Arizona State University, Tempe, AZ 85287-1704
M. J. Kim
Affiliation:
Center for Solid State Science, Arizona State University, Tempe, AZ 85287-1704
R.W. Carpenter
Affiliation:
Center for Solid State Science, Arizona State University, Tempe, AZ 85287-1704
R. F. Davis
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907
Get access

Abstract

Ohmic contact strategies for n- and p-type GaN have been investigated electrically, chemically, and microstructurally using transmission line measurements, high-resolution EELS and cross-sectional TEM, respectively. The contributions to contact performance from work function differences, carrier concentrations, annealing treatments, and interface metallurgy have been examined. The contact materials of Ti, TiN, Au, and Au/Mg were deposited via electron beam evaporation; Al was deposited via thermal evaporation. As-deposited Al and TiN contacts to highly doped n-GaN were ohmic, with room-temperature specific contact resistivities of 8.6×10−5 Ω cm2 and 2.5×10−5 Ωcm2 respectively. The Ti contacts developed low-resistivity ohmic behavior as a result of annealing; TiN contacts also improved with further heat treatment. For p-GaN, Au became ohmic with annealing, while Au/Mg contacts were ohmic in the as-deposited condition. The performance, structure, and composition of different contact schemes varied widely from system to system. An integrated analysis of the results of this study is presented below and coupled with a discussion of the most appropriate contact systems for both n- and p-type GaN.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable