Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T21:38:08.108Z Has data issue: false hasContentIssue false

Oxidation Resistant Dilute Copper (Boron) Alloy Films Prepared by DC-Magnetron Cosputtering

Published online by Cambridge University Press:  15 February 2011

S. Hymes
Affiliation:
Center for Integrated Electronics and Electronics Manufacturing, Rensselaer Polytechnic Institute, Troy, NY 12180
K. S. Kumar
Affiliation:
Center for Integrated Electronics and Electronics Manufacturing, Rensselaer Polytechnic Institute, Troy, NY 12180
S. P. Murarka
Affiliation:
Center for Integrated Electronics and Electronics Manufacturing, Rensselaer Polytechnic Institute, Troy, NY 12180
W. Wang
Affiliation:
Department of Physics, The University at Albany - SUNY, Albany, NY 12222
W. A. Lanford
Affiliation:
Department of Physics, The University at Albany - SUNY, Albany, NY 12222
Get access

Abstract

To enhance the corrosion resistance and reliability of the proposed copper interconnections in silicon integrated circuits, alloying with small amounts thermodynamically favorable elements has been pursued. In the present investigation dilute copper (boron) alloy thin films (in boron concentration range of 0-4 at % in copper) were deposited by DC magnetron co-sputtering using a high purity copper and Cu-4 at % B targets. Films were then annealed in Ar-3% H2, pure Ar, vacuum, and air ambients in the temperature range of 200–500°C. Sheet resistance, Rutherford backscattering, x-ray diffraction measurements were made to characterize the films. The residual resistivity of the as-deposited alloy films was found to be 5.3 μΩ-cm/at %. To obtain sufficiently low working resistivity, an alloy content below 0.5 at % is suggested for application as a potential “metallization material. The addition of boron, which is the common dopant in Si, to the copper films offers considerable oxidation protection. The resulting oxidation rates are considerably lower than that for pure copper films. All this will be presented and discussed.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable