Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T17:03:39.533Z Has data issue: false hasContentIssue false

Performance and Reliability of Thick Cu Interconnects for RF and Analog/Mixed Signal Technology

Published online by Cambridge University Press:  29 May 2013

E. Cooney
Affiliation:
IBM Microelectronics, 1000 River Street, Essex Junction, VT, 05452
J.P. Gambino
Affiliation:
IBM Microelectronics, 1000 River Street, Essex Junction, VT, 05452
F. Anderson
Affiliation:
IBM Microelectronics, 1000 River Street, Essex Junction, VT, 05452
J. He
Affiliation:
IBM Microelectronics, 1000 River Street, Essex Junction, VT, 05452
T. Lee
Affiliation:
IBM Microelectronics, 1000 River Street, Essex Junction, VT, 05452
E. White
Affiliation:
IBM Microelectronics, 1000 River Street, Essex Junction, VT, 05452
X. Liu
Affiliation:
IBM T.J. Watson Research Center, Yorktown Heights, NY 10598
C. Cabral Jr
Affiliation:
IBM T.J. Watson Research Center, Yorktown Heights, NY 10598
T. Shaw
Affiliation:
IBM T.J. Watson Research Center, Yorktown Heights, NY 10598
Get access

Abstract

Wireless communications such as those in cell phones are utilizing increasing chip design complexity. For example analog mixed-signal chips can contain RF capability which requires integrated inductors [1,2]. High performance RF designs are enabled by the use of thick Copper (Cu) and Aluminum (Al) wires (>3um). In particular, the quality factor of the inductor, which is the ratio of magnetic stored energy over average dissipation, is dependent on the metal thickness. High quality factors, can be achieved by using thick Cu inductors. In some applications, the total thickness of Cu in the inductor can be as much as 12 um.

The fabrication of thick Cu layers is in many ways easier than that of thin Cu layers. For example, there are no limitations in terms of lithography or liner and seed layer thickness. However, there are still challenges with fabrication due to stress. Cracking of the dielectric can occur, due to the mismatch in coefficient of thermal expansion between Cu and SiO2, and due to the thick Cu layers in the inductor stack. Both the layout and the processing must be optimized to ensure that cracking does not occur.

This paper will discuss current applications, inductor design, and the reliability challenges and solutions associated with thick Cu interconnects.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable