Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T19:30:09.854Z Has data issue: false hasContentIssue false

Phase Separation in Al2O3 Sol-gel System Incorporated with High Molecular Weight Poly(ethylene oxide)

Published online by Cambridge University Press:  17 March 2011

Yasuaki Tokudome
Affiliation:
Department of Material Chemistry, Graduate School of Engineering, Kyoto University, Kyoto-Daigaku-Katsura, Nishikyo-ku, kyoto, 615-8510, Japan
Kazuki Nakanishi*
Affiliation:
Department of Chemistry, Graduate School of Science, Kyoto University, Kitashirakawa, Sakyo-ku, kyoto, 606-8502, Japan
Koji Fujita
Affiliation:
Department of Material Chemistry, Graduate School of Engineering, Kyoto University, Kyoto-Daigaku-Katsura, Nishikyo-ku, kyoto, 615-8510, Japan
Kiyotaka Miura
Affiliation:
Department of Material Chemistry, Graduate School of Engineering, Kyoto University, Kyoto-Daigaku-Katsura, Nishikyo-ku, kyoto, 615-8510, Japan
Kazuyuki Hirao
Affiliation:
Department of Material Chemistry, Graduate School of Engineering, Kyoto University, Kyoto-Daigaku-Katsura, Nishikyo-ku, kyoto, 615-8510, Japan
*
To whom correspondence should be addressed.
Get access

Abstract

Pure alumina monoliths with well-defined macropores and mesostructured skeleton have been synthesized via a spontaneous route from the aqueous and ethanolic solution of aluminum salts in the presence of propylene oxide and high molecular weight poly(ethylene oxide)(PEO). The addition of propylene oxide to the starting solution controls the gelation, while the addition of PEO induces the phase separation. Appropriate choice of the starting composition, with which the phase separation and gelation concur, produces large-dimension (10mm×10mm×10mm), bicontinuous macroporous Al2O3 monoliths. The mean size of the continuously connected pores is controlled in the micrometer range, depending on the PEO concentration and polarity of the solution. On the other hand, micropores and mesopores, originated from the interstices among primary particles, exhibit median pore size of about 2.6 nm and the BET surface area as high as 396 m2/g after dried temperature at 40 °C.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable