Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-18T07:20:23.030Z Has data issue: false hasContentIssue false

Photo-Chemical Etching on Silicon-Carbide by Using Krf Excimer Laser and Xe2* Excimer Lamp

Published online by Cambridge University Press:  15 February 2011

K. Hasegawa
Affiliation:
Engineering of Tokai University, 1117 Kitakaname, Hiratsuka, Kanagawa, 259-12, JAPAN
M. Murahara
Affiliation:
Engineering of Tokai University, 1117 Kitakaname, Hiratsuka, Kanagawa, 259-12, JAPAN
Get access

Abstract

Silicon-carbide (SiC) has excellent refractivity in the range of soft X-ray and is well-used as a diffraction grating for Synchrotron-radiation (SR) light. This material has a high melting point, hardness and chemical stability. Therefore, etching of the material by chemical or physical methods is very difficult. We reported a photo-chemical etching method in which a SiC surface is placed in NF3 gas atmosphere and irradiated by the Xe2* excimer lamp light parallelly and the grating patterned KrF laser light of 248nm perpendicularly on the sample surface. The Xe2* excimer lamp light are employed for NF3 gas decomposition, and KrF laser light used for excitation on the sample surface. This photochemical etching reaction are detected by XPS, QMS and FTIR measurements. This method achieved 0.18 Å/shot in etching efficiency, and became maximum approximately 7 times as high as ArF laser light for photodecomposition.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable