Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T09:28:07.251Z Has data issue: false hasContentIssue false

Plasma Etching of Tungsten Silicide Structures Using NF3-Halocarbon Etchants

Published online by Cambridge University Press:  21 February 2011

John G. Langan
Affiliation:
Air Products and Chemicals, Inc., 7201 Hamilton Blvd., Allentown, PA. 18195
Jeffrey M. Parks
Affiliation:
Sherman Fairchild Laboratory, Lehigh University, Bethlehemm, PA. 18015
Mark A. George
Affiliation:
Air Products and Chemicals, Inc., 7201 Hamilton Blvd., Allentown, PA. 18195
Ralph J. Jaccodine
Affiliation:
Sherman Fairchild Laboratory, Lehigh University, Bethlehemm, PA. 18015
Get access

Abstract

The feasibility of utilizing NF3-halocarbon mixed etchants to anisotropically etch tungsten silicide structures has been investigated. CVD tungsten silicide was etched with various mixtures of CF3Cl and CF2Cl3 to which 0 to 50 vol percent NF3 was added under a variety of conditions. Anisotropy, undercutting, and notching were evaluated using cross-sectional SEM. Relative etch rates and selectivity for each gas mixture were also determined. Halocarbon residues were investigated using XPS and related to side wall passivity.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable