Hostname: page-component-74656f9884-54qdv Total loading time: 0 Render date: 2026-11-10T13:02:48.314Z Has data issue: false hasContentIssue false
  • English
  • Français

Polymer Curing Using Variable Frequency Microwave Processing

Published online by Cambridge University Press:  15 February 2011

April D. Surret ,
Robert J. Lauf ,
Felix L. Paulauskas  and
Arvid C. Johnson
April D. Surret
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, TN 37831–6087
Robert J. Lauf
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, TN 37831–6087
Felix L. Paulauskas
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, TN 37831–6087
Arvid C. Johnson
Affiliation:
Microwave Laboratories, Inc., 8917 Glenwood Avenue, Raleigh, NC 27612
Get access

Abstract

Epoxy resin was cured by microwave heating using a variable frequency furnace. Curing behavior and uniformity were characterized by visual inspection, hardness, and differential scanning calorimetry. Frequency sweeping was used as a means of mode stirring to minimize power nonuniformities in the furnace cavity. Cure times were reduced by half and with the appropriate post-cure treatment (also done in the microwave furnace) the resin had a glass transition temperature of 165–175°C. Small amounts of additives such as carbon black and various oxide pigments were tested to determine if they would improve microwave coupling and further reduce cure time. There was little or no effect at a standard concentration of 1 wt% pigment.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 347: Symposium O – Microwave Processing of Materials IV , 1994 , 691
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Paulauskas, F.L and Meek, T.T., “Processing of Thermoset Prepreg Laminate via Exposure to Microwave Radiation,” to be published elsewhere in these proceedings.Google Scholar
2. Lewis, D.A., Summers, J.D., Ward, T.C., and McGrath, J.E., 1992, “Accelerated Imidization Reactions Using Microwave Radiation,” J. Polymer Sci.: Part A: Polymer Chem. 30, 1647–53.Google Scholar
3. Lauf, R.J., Bible, D.W., Johnson, A.C., and Everleigh, C.A., “2–18 GHz Broadband Microwave Heating Systems,” Microwave Journal 36(11), 24 (1993).Google Scholar
4. Johnson, A.C., Lauf, R.J., and Surrett, A.D., “Effect of Bandwidth on Uniformity of Energy Distribution in a Multi-Mode Cavity,” to be published elsewhere in these proceedings.Google Scholar
5. Lauf, R.J., Paulauskas, F.L., and Johnson, A.C., “Polymer Curing in a Variable Frequency Oven,” 28th Microwave Symposium Proceedings (International Microwave Power Institute, Manassas, VA, 1993), pp. 150–55.Google Scholar