Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T02:30:59.966Z Has data issue: false hasContentIssue false

Porous Morphology and Oxidation Kinetics in a-Si:H RF Sputtered by He/H2

Published online by Cambridge University Press:  26 February 2011

J. Shinar
Affiliation:
Ames Laboratory and Physics Department, Iowa State University, Ames, IA 50011
R. Shinar
Affiliation:
Hicroelectronics Research Center, Iowa State University, Ames, IA 50011
S. Mitra
Affiliation:
Ames Laboratory and Physics Department, Iowa State University, Ames, IA 50011
M. L. Albers
Affiliation:
Ames Laboratory and Physics Department, Iowa State University, Ames, IA 50011
H. R. Shanks
Affiliation:
Ames Laboratory and Physics Department, Iowa State University, Ames, IA 50011Hicroelectronics Research Center, Iowa State University, Ames, IA 50011
T. D. Moustakas
Affiliation:
Corporate Research Laboratories, Exxon Research and Engineering Co., Clinton Township, Annandale, NJ 08801
Get access

Abstract

a-Si:H films rf sputtered in 10 mT He and 0.5 mT H2, in contrast to those prepared in Ar/H2 or Xe/H2, exhibit port depositional oxidation when sputtered at power levels of 0.55 – 3.3 W/cm2 (100 – 600W). SEM measurements show that the morphology of the films evolves from a cracked, microcrystalline, glassy one at higher rf power levels to a porous one at low power levels. This trend is also correlated with a sharply increasing density of Si-H2 dihydride bonds at decreasing rf levels. Auger depth profiles of the oxygen concentration in the films agree with a diffusion controlled process of a source solute of O2 molecules into a semi-infinite solid solvent. Yet IR absorption measurements indicate that the oxygen is confined to the internal surfaces of the microvoids. The diffusion constant is a very sensitive functi n of the sputtering conditions. At low rf power levels, it is as low as 10−16 – 10−1 cm2 /sec at room temperature, but increases to ∼10−13 at 250 – 350°C.These results are discussed in terms of a porous network of microvoids, through which the O2 “squeezes” into the film.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable