Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T19:05:08.105Z Has data issue: false hasContentIssue false

Preparation and Characterization of Li4/3Ti5/3O4 Thin Films by Sol-gel Method

Published online by Cambridge University Press:  26 February 2011

C. Hu
Affiliation:
whhuchen@yahoo.com.cn, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan University of Technology, Wuhan430070,Hubei, PR China., Wuhan, 430070, China, People's Republic of
W. Zhang
Affiliation:
whhuchen@yahoo.com.cn, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan, 430070, China, People's Republic of
H. Hao
Affiliation:
whhuchen@yahoo.com.cn, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan, 430070, China, People's Republic of
M. H. Cao
Affiliation:
whhuchen@yahoo.com.cn, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan, 430070, China, People's Republic of
S. J. Lai
Affiliation:
juanzi211@163.com, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan, 430070, China, People's Republic of
X. J. Zhu
Affiliation:
whhuchen@yahoo.com.cn, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan, 430070, China, People's Republic of
H. X. Liu
Affiliation:
lhxhp@mail.whut.edu.cn, Wuhan University of Technology, State Key Laboratory of Advanced Technology for Materials Synthesis and Processing, Wuhan, 430070, China, People's Republic of
Get access

Abstract

In the study Li4/3Ti5/3O4 thin films were deposited on Pt substrates by sol-gel method using a spin coator. The coated films are dried at 310-360 °C, and then annealed at 500-800 °C for 30min. The prepared films were characterized by X-ray diffraction, atomic force microscope and scanning electron microscope. The results indicated that the prepared film belonged to a spinel structure and had a uniform morphology. Electrochemical properties of the prepared electrode films were evaluated by using a discharge and charge test. From these results, it can be showed that the thin film electrode annealed at 700 °C exhibited good crystallinity, smooth surface morphology, high capacity, and good rechargeability. Therefore, This film was therefore suitable for use as an anode for thin-film microbatteries.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable