Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T15:15:10.463Z Has data issue: false hasContentIssue false

Preparation and Properties of PVC-Silica Composites using Different Catalysts Via Sol-Gel Process

Published online by Cambridge University Press:  10 February 2011

Khan M. Asif
Affiliation:
Chemistry Department, Kansas State University, Manhattan, KS 66506, asif@ksu.edu
M.I. Sarwar
Affiliation:
Chemistry Department, Quaid-i-Azam University, Islamabad, PAKISTAN
Z. Ahmad
Affiliation:
Chemistry Department, Quaid-i-Azam University, Islamabad, PAKISTAN
Get access

Abstract

Novel micro-composites from Polyvinyl chloride (PVC) and silica were prepared using sol-gel technique. Different catalysts were used for the in-situ generation of silica network from tetraethylorthosilicate (TEOS) in the PVC matrix. Thin transparent films containing various proportions of silica in PVC were cast by the solvent elution technique. Mechanical properties of these films were studied. The results showed an increase in the value of Young's modulus and strain at rupture by the addition of small amount of silica in PVC. However, the stress at yields point and stress at rupture decreased with the addition of silica contents. Scanning electron microscopy (SEM-EDAX) studies were also performed on these samples.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable