Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T03:56:59.828Z Has data issue: false hasContentIssue false

Pyrolytic Laser Direct Writing of Nickel Over Polyimides

Published online by Cambridge University Press:  28 February 2011

S. J. Bezuk
Affiliation:
UNISYS Corp., Semiconductor Operations, St. Paul, MN 55121
R. J. Baseman
Affiliation:
UNISYS Corp., Semiconductor Operations, St. Paul, MN 55121
C. Kryzak
Affiliation:
UNISYS Corp., Semiconductor Operations, St. Paul, MN 55121
K. Warner
Affiliation:
UNISYS Corp., Semiconductor Operations, St. Paul, MN 55121
G. Thomes
Affiliation:
UNISYS Corp., Semiconductor Operations, St. Paul, MN 55121
Get access

Abstract

Polyimides are of great interest as insulators for microelectronic fabrication due to their low dielectric constant and planarizing properties. However, they are thermally sensitive films. Nonetheless, preliminary results clearly demonstrate that nickel lines readily can be laser-pyrolytically drawn over polyimide films.

While elevated laser power will damage underlying polyimide films, microelectronic quality nickel lines can be drawn using nickel carbonyl at relatively low laser intensities over polyimides with little or no change in the electrical characteristics. Polyimide's lower thermal conductivity relative to silicon dioxide facilitates increased nickel deposition rates. Self-limiting effects have been observed during the deposition that can lead to near microelectronically ideal line cross sections.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable