Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T16:02:23.581Z Has data issue: false hasContentIssue false

Rapid Thermal Annealing of Pre-Amorphized B andBF2-Implanted Silicon

Published online by Cambridge University Press:  25 February 2011

I.D. Calder
Affiliation:
Northern Telecom Electronics, Box 3511, Stn. C, Ottawa, Ontario, K1Y 4H7
H.M. Naguib
Affiliation:
Northern Telecom Electronics, Box 3511, Stn. C, Ottawa, Ontario, K1Y 4H7
D. Houghton
Affiliation:
Bell-Northern Research, Box 3511, Stn. C, Ottawa, Ontario, K1Y 4H7
F.R. Shepherd
Affiliation:
Bell-Northern Research, Box 3511, Stn. C, Ottawa, Ontario, K1Y 4H7
Get access

Abstract

Shallow p+n junctions have been formed through a combination ofpre-amorphization of the silicon surface by implantation of 28Si, 33Ar, or 73Ge, low energy implantation of boron or BF2+, and rapid thermal annealing (RTA) in a tunqsten halogen lampsystem. Both pre-amorphization and RTA are required to form a shallow(<0.25 μm) junction, for either boron or BF2+. Arqon pre-amorphization results in poor electrical activationof the boron, while germanium gives the lowest sheet resistivity, but isresponsible for a deep boron tail during implantation. The residual damageis characterized by a plane of dislocation loops centred either close to theboron concentration peak, for B+ implantation into a crystallinesubstrate, or at the original amorphous-crystalline interface, forpre-amorphized specimens.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable