Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T10:14:20.733Z Has data issue: false hasContentIssue false

Realization of 3D Isotropic Negative Index Materials using Massively Parallel and Manufacturable Microfabrication and Micromachining Technology

Published online by Cambridge University Press:  01 February 2011

Logeeswaran VJ
Affiliation:
lvjay@ucdavis.edu, University of California at Davis, Electrical & Computer Engineering, Kemper Hall,, One Shields Ave,, DAVIS, CA, 95616, United States
M. Saif Islam
Affiliation:
sislam@ucdavis.edu, University of California at Davis, Electrical & Computer Engineering, Kemper Hall,, One Shields Ave,, DAVIS, CA, 95616, United States
Mei Lin Chan
Affiliation:
cmlchan@ucdavis.edu, University of California at Davis, Mechanical & Aeronautical Engineering, Bainer Hall,, One Shields Ave,, DAVIS, CA, 95616, United States
David A Horsley
Affiliation:
dahorsley@ucdavis.edu, University of California at Davis, Mechanical & Aeronautical Engineering, Bainer Hall,, One Shields Ave,, DAVIS, CA, 95616, United States
Wei Wu
Affiliation:
wei.wu@hp.com, Hewlett Packard Laboratories, Quantum Science Research, 1501 Page Mill Rd, Palo Alto, CA, 94304, United States
Shih-Yuan Wang
Affiliation:
sywang@hp.com, Hewlett Packard Laboratories, Quantum Science Research, 1501 Page Mill Rd, Palo Alto, CA, 94304, United States
R. Stanley Williams
Affiliation:
stan.williams@hp.com, Hewlett Packard Laboratories, Quantum Science Research, 1501 Page Mill Rd, Palo Alto, CA, 94304, United States
Get access

Abstract

In this paper, we present a method to realize a three dimensional (3D) homogeneous and isotropic negative index materials (3D-NIMs) fabricated using a low cost and massively parallel manufacturable microfabrication and microassembly technique. The construction of self-assembled 3D-NIM array was realized through two dimensional (2-D) planar microfabrication techniques exploiting the as-deposited residual stress imbalance between a bi-layer consisting of e-beam evaporated metal (650nm of chromium) and a structural layer of 500nm of low stress silicon nitride deposited by LPCVD on a silicon substrate.

A periodic continuation of a single rectangular unit cell consisting of split-ring resonators (SRR) and wires were fabricated to generate a 3D assembly by orienting them along all three Cartesian axes. The thin chromium and silicon nitride bi-layer is formed as hinges. The strain mismatch between the two layers curls the structural layer (flap) containing the SRR upwards. The self-assembled out-of-plane angular position depends on the thickness and material composing the bi-layer. This built-in stress-actuated assembly method is suitable for applications requiring a thin dielectric layer for the SRR. The split-ring resonators and other structures are created on the membrane which is then assembled into the 3-D configuration.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable