Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T09:52:02.949Z Has data issue: false hasContentIssue false

Refrigerative Stereolithography Using Sol-Gel Transformable Photopolymer Resin and Direct Masking*

Published online by Cambridge University Press:  10 February 2011

T. Murakami
Affiliation:
Department of Engineering Synthesis, The University of Tokyo Hongo 7-3-1, Bunkyo-ku, Tokyo 113-8656, Japan, murakami@mech.t.u-tokyo.ac.jp
A. Kamimura
Affiliation:
Department of Engineering Synthesis, The University of Tokyo Hongo 7-3-1, Bunkyo-ku, Tokyo 113-8656, Japan, murakami@mech.t.u-tokyo.ac.jp
N. Nakajima
Affiliation:
Department of Engineering Synthesis, The University of Tokyo Hongo 7-3-1, Bunkyo-ku, Tokyo 113-8656, Japan, murakami@mech.t.u-tokyo.ac.jp
Get access

Abstract

The authors have been studying a new fabrication method termed “refrigerative stereolithography” which uses a gel resin layer instead of a liquid layer as in conventional stereolithography. This paper proposes the “direct masking method” in which a masking pattern is drawn to block direct light exposure to the surface of the gel resin layer. With such masks, we can avoid surplus growth only in the regions where it is unnecessary to improve height direction accuracy and resolution. Also, we can solidify the required section shape selectively using the masks and a lamp instead of laser scan patterns. The effectiveness of refrigerative stereolithography with the direct masking method is discussed and confirmed by some experimental results.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable