Hostname: page-component-7b7567c8c-p67k6 Total loading time: 0 Render date: 2026-11-19T10:24:36.099Z Has data issue: false hasContentIssue false

Residual Stress Measurement in Silicon Substrate After Local Thermal Oxidation Using Microscopic Raman Spectroscopy

Published online by Cambridge University Press:  26 February 2011

Hideo Miura
Affiliation:
HITACHI, Ltd., 502 Kandatsu, Tsuchiura, Ibaraki 300, Japan
Hiroshi Sakata
Affiliation:
HITACHI, Ltd., 502 Kandatsu, Tsuchiura, Ibaraki 300, Japan
Shinji Sakata Merl
Affiliation:
HITACHI, Ltd., 502 Kandatsu, Tsuchiura, Ibaraki 300, Japan
Get access

Abstract

The residual stress in silicon substrates after local thermal oxidation is discussed experimentally using microscopic Raman spectroscopy. The stress distribution in the silicon substrate is determined by three main factors: volume expansion of newly grown silicon–dioxide, deflection of the silicon–nitride film used as an oxidation barrier, and mismatch in thermal expansion coefficients between silicon and silicon dioxide.

Tensile stress increases with the increase of oxide film thickness near the surface of the silicon substrate under the oxide film without nitride film on it. The tensile stress is sometimes more than 100 MPa. On the other hand, a complicated stress change is observed near the surface of the silicon substrate under the nitride film. The tensile stress increases initially, as it does in the area without nitride film on it. However, it decreases with the increase of oxide film thickness, then the compressive stress increases in the area up to 170 MPa. This stress change is explained by considering the drastic structural change of the oxide film under the nitride film edge during oxidation.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable