Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-15T13:00:18.473Z Has data issue: false hasContentIssue false

Rheological and Related Colloidal Aspects of Aqueous Processing that affect the Development of Microstructure

Published online by Cambridge University Press:  28 February 2011

Alan Bleier
Affiliation:
Oak Ridge National Laboratory, Metals and Ceramics Division, P. O. Box 2008, Oak Ridge, TN 37831–6068
C. Gary Westmoreland
Affiliation:
Oak Ridge National Laboratory, Metals and Ceramics Division, P. O. Box 2008, Oak Ridge, TN 37831–6068
Get access

Abstract

Shear flow in α-A12O3 suspensions having a volume fraction of solids (φ) in the range between 0.17 and 0.50 was investigated between pH 4 and 12. It is Newtonian if the magnitude of the zeta potential exceeds a critical value which depends on φ;its value is 39 mV if φ= 0.40 and 74 mV if φ= 0.50. If this potential is less than the critical value, shear flow is pseudoplastic; its yield value markedly changes (e.g., 0 to >100 Pa) in a slightly φ-dependent, narrow pH range (<0.5 units). If a second oxide, t-ZrO2 , is present, its pH-dependent colloidal behavior governs the overall rheology, though its concentration may be only 11 % that of α-A12O3. Scanning electron microscopy of composite pieces indicates that a detrimental, rheologically detectable interaction between α-Al2O3 and t-ZrO2 can be avoided and the distribution of t-ZrO2 can be optimized during pressure casting by control of pH. Best conditions correspond to either Newtonian flow or pseudoplastic flow with a very low yield value.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable