Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T20:34:37.630Z Has data issue: false hasContentIssue false

Scanning Scratch Tests for Evaluating the Adhesion of Thin Oxide Films on Stainless Steel

Published online by Cambridge University Press:  21 February 2011

V. A. C. Haanappel
Affiliation:
University of Twente, Department of Chemical Technology, P.O. Box 217, 7500 AE Enschede, The Netherlands.
H. D. van Corbach
Affiliation:
University of Twente, Department of Chemical Technology, P.O. Box 217, 7500 AE Enschede, The Netherlands.
T. Fransen
Affiliation:
University of Twente, Department of Chemical Technology, P.O. Box 217, 7500 AE Enschede, The Netherlands.
P. J. Gellings
Affiliation:
University of Twente, Department of Chemical Technology, P.O. Box 217, 7500 AE Enschede, The Netherlands.
Get access

Abstract

Amorphous alumina films were deposited by metal-organic chemical vapour deposition (MOCVD) on stainless steel, type AISI 304. The MOCVD experiments were performed in nitrogen at low pressure (0.17 kPa (1.25 torr)).

The effect of deposition temperature (200 − 380 °C), growth rate, film thickness, and post-deposition thermal treatment on the mechanical properties was studied. The experiments were performed with a scanning-scratch tester. The experiments are based on the estimation of the film adhesion to the substrate by determining a critical load, Lc: the load where the film starts to spall or to delaminate.

The best mechanical properties were obtained with unannealed samples. After thermal annealing the critical load decreases. Regarding the unannealed samples, the critical load increased with increasing film thickness. The deposition temperature and the growth rate had no effect on the critical load.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable