Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-18T03:15:21.290Z Has data issue: false hasContentIssue false

Selective Rapid Thermal Cvd of Germanium

Published online by Cambridge University Press:  21 February 2011

D.T. Grider
Affiliation:
North Carolina State University, Department of Electrical and Computer Engineering, Box 7911, Raleigh, NC 27695-7911
M.C. Özttürk
Affiliation:
North Carolina State University, Department of Electrical and Computer Engineering, Box 7911, Raleigh, NC 27695-7911
J.J. Wortman
Affiliation:
North Carolina State University, Department of Electrical and Computer Engineering, Box 7911, Raleigh, NC 27695-7911
M.A. Littlejohn
Affiliation:
North Carolina State University, Department of Electrical and Computer Engineering, Box 7911, Raleigh, NC 27695-7911
Y. Zhong
Affiliation:
North Carolina State University, Department of Electrical and Computer Engineering, Box 7911, Raleigh, NC 27695-7911
D. Batchelor
Affiliation:
North Carolina State University, Department of Materials Science and Engineering, Box 7907, Raleigh, NC 27695-7907
P. Russell
Affiliation:
North Carolina State University, Department of Materials Science and Engineering, Box 7907, Raleigh, NC 27695-7907
Get access

Abstract

Selective depositions of germanium thin films have been investigated in a cold-wall, lamp heated rapid thermal processor. Films were deposited at low pressures (1 Torr-8 Torr) using the thermal decomposition of germane. Selectivity was maintained throughout the temperature range investigated, 350°C-600°C. Growth rates as high as 800 Å/min were obtained at 425°C where deposition is controlled by the surface reactions, making germanium compatible with the throughput requirements of single wafer manufacturing. Three dimensional growth was seen at temperatures above 450°C resulting in a rough surface morphology. Smooth films were deposited below 450°C with the films characterized by two dimensional growth. In this work, germanium is considered as a potential material to fabricate MOS transistors with raised source and drain junctions (UPMOS). Kelvin structures were fabricated to study the effect of the intermediate germanium layer between aluminum and silicon on contact resistance. It is shown that contact resistivity is improved by approximately 17% using an Al/p-Ge/p+-Si structure. In this work, it is also shown that titanium germanide formation can be used as a means of reducing the resistivity of the Ge buffer layer.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable