Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-12T17:59:30.599Z Has data issue: false hasContentIssue false
  • English
  • Français

Shock-Induced Defects in Bulk Materials

Published online by Cambridge University Press:  10 February 2011

George T. Gray III
George T. Gray III*
Affiliation:
Material Science and Technology Division, Los Alamos National Laboratory, Los Alamos, New Mexico 87545
Get access

Abstract

In this paper examples of the shock-induced defects produced during shock compression which correlate with microstructure / mechanical property changes induced in materials due to shock prestraining are discussed. The characteristics of the shock impulse(peak shock pressure, pulse duration, and rarefaction rate) imparted to the material under investigation and the shock-induced defects produced in numerous metals and alloys are compared with their deformation behavior at ordinary rates of deformation. Examples of the range of defects observed in shock-recovered metals and alloys, include: dislocations, deformation twins, point defects, and residual metastable remnants from pressure-induced phase transformations. Results concerning the influence of interstitial content on the propensity of ω-phase formation and its structure in high-purity and A-70 Ti are presented. The influence of shock-wave deformation on the phase stability and substructure evolution of high-purity (low-interstitial) titanium and A-70 (3700 ppm oxygen) titanium were probed utilizing real-time velocity interferometry (VISAR) and “soft” shock-recovery techniques. Suppression of the α-ω pressure-induced phase transformation in A-70 Ti, containing a high interstitial oxygen content, is seen to simultaneously correspond with the suppression of deformation twinning.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 499: Symposium DD – High Pressure Materials Research , 1997, 87
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Smith, C.S., Trans. Metall. Soc. AIME 214, 574–589 (1958).Google Scholar
2. Gray, G.T. III, in High Pressure Shock Compression of Solids, edited by Asay, J.R. and Shahinpoor, M. (Springer-Verlag, New York, NY, 1993), pp. 187–215.Google Scholar
3. Dieter, G.E., in Response of Metals to High Velocity Deformation, edited by Shewmon, P.G. and Zackay, V.F. (Interscience, New York, 1961), pp. 409–446.Google Scholar
4. Hornbogen, E., in High Energy Rate Working of Metals (NATO, Oslo, Norway, 1964), pp. 345–364.Google Scholar
5. Doran, D.G. and Linde, R.K., Solid State Physics 19, 229–290 (1966).Google Scholar
6. Zukas, E.G., Metals Eng. Quart. 6, 1–20 (1966).Google Scholar
7. Mahajan, S., Physica Status Solidi (A) 2, 187–201 (1970).Google Scholar
8. Leslie, W.C., in Metallurgical Effects at High Strain Rates, edited by Rhode, R.W., Butcher, B.M., Holland, J.R. et al. (Plenum Press, New York, 1973), pp. 571.Google Scholar
9. Murr, L.E., in Shock Waves and High Strain Rate Phenomena in Metals, edited by Meyers, M.A. and Murr, L.E. (Plenum, New York, 1981), pp. 607–673.Google Scholar
10. Murr, L.E., in Materials at High Strain Rates, edited by Blazynski, T.Z. (Elsevier Applied Science, London, 1987), pp. 1–46.Google Scholar
11. Fowler, C.M., Minshall, F.S., and Zukas, E.G., in Response of Metals to High Velocity Deformation, edited by Shewmon, P.G. and Zackay, V.F. (Interscience, New York, 1961), pp. 275–308.Google Scholar
12. Blumenthal, W.R., Gray, G.T. III, and Claytor, T.N., J. Mat. Sci. 29, 4567–4576 (1994).Google Scholar
13. Kocks, U.F., Argon, A.S., and Ashby, M.F., Prog. Matls. Sci. 19, 1 (1975).Google Scholar
14. Swann, P.R., in Electron Microscopy and Strength of Crystals, edited by Thomas, G. and Washbum, J. (Wiley-Interscience, New York, 1963), pp. 131–181.Google Scholar
15. Keh, A.S. and Weissmann, S., in Electron Microscopy and Strength of Crystals, edited by Thomas, G. and Washburn, J. (Wiley-Interscience, New York, 1963), pp. 231–300.Google Scholar
16. Sevillano, J.G., Houtte, P.v., and Aernoudt, E., Prog, in Matls. Sci. 25, 69–412 (1981).Google Scholar
17. Murr, L.E., in Shock Waves and High Strain Rate Phenomena in Metals, edited by Meyers, M.A. and Murr, L.E. (Plenum Press, New York, 1981), pp. 607–673.Google Scholar
18. Gray, G.T. III, in Modeling the Deformation of Crystalline Solids, edited by Lowe, T.C., Rollett, A.D., Follansbee, P.S. et al. (The Metallurgical Society of AIME, Warrendale, PA, 1991), pp. 145–158.Google Scholar
19. Gray, G.T. III and Vecchio, K.S., Metall, and Matls. Trans. 26A, 2555–2563 (1995).Google Scholar
20. Gray, G.T. III and Huang, J.C., Materials Science and Engineering A145, 21–35 (1991).Google Scholar
21. Gray, G.T. III and Follansbee, P.S., in Impact Loading and Dynamic Behavior of Materials. edited by Chiem, C.Y., Kunze, H.-D., and Meyer, L.W. (Deutsche Gesellschaft fuer Metallkunde, Germany, 1988), Vol. 2, pp. 541–548.Google Scholar
22. Price, P., in Electron Microscopy and Strength of Crystals, edited by Thomas, G. and Washburn, J. (Wiley-Interscience, New York, 1963), pp. 41–130.Google Scholar
23. Gray, G.T. III, in Encyclopedia of Materials Science and Engineering, edited by Cahn, R.W. (Pergamon Press, Oxford, 1990), Vol. Supplementary Volume 2, pp. 859–866.Google Scholar
24. Gray, G.T. III, Acta Metallurgica 36, 1745–1754 (1988).Google Scholar
25. Gray, G.T. III and Follansbee, P.S., in Shock Waves in Condensed Matter 1987. edited by Schidt, S.C. and Holmes, N.C. (North-Holland Press, NY, 1988), pp. 339–342.Google Scholar
26. Gray, G.T. III and Morris, C.E., in 6th World Conference on Titanium, edited by Lacombe, P., Tricot, R., and Beranger, G. (Les Editions de Physique, France, 1989), Vol. 1, pp. 269–274.Google Scholar
27. Hirth, J.P. and Lothe, J., in Theory of Dislocations (Wiley Publishers, 1982).Google Scholar
28. Weertman, J., in Response of Metals to High Velocity Deformation, edited by Shewmon, P.G. and Zackay, V.F. (Interscience Publishers, New York, 1961), pp. 205–247.Google Scholar
29. Gray, G.T. III and Huang, J.C., Mater. Sci. Engng A 145, 21–35 (1991).Google Scholar
30. Kressel, H. and Brown, N., J. Appl. Phys. 38, 1618 (1967).Google Scholar
31. Meyers, M.A. and Murr, L.E., in Shock Waves and High Strain Rate Phenomena in Metals. edited by Meyers, M.A. and Murr, L.E. (Plenum, New York, 1981), pp. 487–530.Google Scholar
32. Duvall, G.E. and Graham, R.A., Rev. Mod. Phys. 49, 523–579 (1977).Google Scholar
33. Sikka, S.K., Vohra, Y.K., and Chidambaram, R., Prog. Matls. Sci. 27, 245 (1982).Google Scholar
34. Kutsar, A.R. and German, V.N., in Titanium and Titanium Alloys, edited by Williams, J.C. and Belov, A.F. (Plenum Press, New York, 1982), pp. 1633–1640.Google Scholar
35. Gray, G.T. III, Morris, C.E., and Lawson, A.C., in Titanium '92 - Science and Technology. edited by Froes, F.H. and Caplan, I.L. (TMS, Warrendale, PA, 1993), pp. 225–232.Google Scholar
36. Song, S. and Gray, G.T., in High-Pressure Science and Technology-1993 AIP Conference Proceedings, edited by Schmidt, S.C., Shaner, J.W., Samara, G.A. et al. (American Institute of Physics, 1994), Vol. 309, pp. 251–254.Google Scholar
37. Song, S.G. and Gray, G.T. III, Philos. Mag. 71, 275–290 (1995).Google Scholar
38. Conrad, H., Prog. Matls. Sci. 26, 123–403 (1981).Google Scholar
39. Gray, G.T. III, in High Pressure Shock Compression of Solids, edited by Asay, J.R. and Shahinpoor, M. (Springer-Verlag, New York, 1993), pp. 187–215.Google Scholar
40. McQueen, R.G., Marsh, S.P., Taylor, J.W., Fritz, J.N. et al., in High Velocity Impact Phenomena, edited by Kinslow, R. (Academic Press, New York, 1970), pp. 293–417, 515–568.Google Scholar
41. Williams, J.C., Sommer, A.W., and Tung, P.P., Metall. Trans. 3, 2979–2984 (1972).Google Scholar
42. Magee, C.L., Hoffman, D.W., and Davies, R.G., Philos. Mag. 23, 1531–1540 (1971).Google Scholar
43. Gray, G.T. III, Hixson, R.S., and Morris, C.E., in Shock Compression of Condensed Matter -1991. edited by Schmidt, S.C., Dick, R.D., Forbes, J.W. et al (Elsevier, Amsterdam, 1992), pp. 427–430.Google Scholar
44. Gray, G.T. III and Vecchio, K.S., Metall. Mater. Trans. A 26, 2555–2563 (1995).Google Scholar