Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-18T19:34:50.995Z Has data issue: false hasContentIssue false

Simulation of Multicomponent Thin Film Deposition and Growth

Published online by Cambridge University Press:  15 February 2011

C. P. Burmester
Affiliation:
University of California, Department of Materials Science and Mineral Engineering and Lawrence Berkeley Laboratory, Materials Science Division, Berkeley, CA 94720.
L. T. Wille
Affiliation:
Florida Atlantic University, Department of Physics, Boca Raton, FL 33431.
R. Gronsky
Affiliation:
University of California, Department of Materials Science and Mineral Engineering and Lawrence Berkeley Laboratory, Materials Science Division, Berkeley, CA 94720.
Get access

Abstract

Results from a multicomponent Monte Carlo simulation of the deposition and growth of YBa2Cu3O7 are presented and discussed. In particular, a detailed examination of the growth modes active during different morphological growth conditions is performed. At higher deposition rates, both [001] and [100] epitaxial variants (‘c’ and ‘a’ type growth, respectively) are observed to grow by modes attributed to the classic Volmer-Weber mechanism. At very low deposition rates, the film is observed to grow in a distinct, cyclic, multi-stage process. Small islands of [001] epitaxy nucleate and grow to one unit cell height followed by primarily horizontal growth or “ledge extension” until one unit cell layer has formed. This process then repeats. Simulated RHEED amplitude data from this growth process compares favorably to experimentally obtained data.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable