Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T01:28:37.189Z Has data issue: false hasContentIssue false

Solidification Processing Routes to High Aspect Ratio Reinforcements in γ-TiAl

Published online by Cambridge University Press:  21 February 2011

J. J. Valencia
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
J. P. A. Löfvander
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
J. Rösler
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
C. G. Levi
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
R. Mehrabian
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
Get access

Abstract

Additions of ∼5%B1 and ∼9%Ta to binary γ-TiAl result in the formation of a monoboride isomorphous with TiB but containing Ta in solid solution. This boride exhibits strongly anisotropic growth from the melt, producing rod-like primary phases which are of potential interest for creep strengthening of the γ matrix. Fibrous borides with aspect ratios larger than ∼20 and volume fractions of ∼0.12 have been produced in arc-melted Ti-48AI-9Ta-4.3B alloys. Creep testing at 1255 K indicates that these “in-situ” composites have much higher creep strength than γ-TiAl, but the contribution of the reinforcements is relatively small compared with the solute-strengthening of the matrix.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable