Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T16:28:37.464Z Has data issue: false hasContentIssue false

Soluble Conducting Polythiophenes for Charge Dissipation in Electron Beam Lithography

Published online by Cambridge University Press:  16 February 2011

Wu-Song Huang*
Affiliation:
IBM Microelectronics Division, Hopewell Junction, New York 12533
Get access

Abstract

In electron beam lithography, charging on photoresist usually causes image distortion and placement error. To dissipate the charge, a conductive polymeric layer can be introduced either over or under the photoresist coating. In this paper, we will discuss the approach of using toluene and xylene soluble polyalkylthiophcne in combination with photoacid generator as a discharge underlayer or interlayer beneath photoresist to dissipate the accumulated charge during li-bcam exposure. We will also discuss the use of water soluble acid or ammonium salt form of poly 3- (cthanesulfonate) thiophene as discharge. toplayer. During the resist image developing process, the toplayer will be removed by aqueous base. Therefore, it is advantageous to use discharge toplayer due to its simplicity. In this study, the salt and acid form of poly 3- (ethanesulfonate) thiophene was synthesized through chemical polymerization of the corresponding methanesulfonate ester. It exhibits the same properties as that of electrochemically synthesized polymer reported in the literature.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable