Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T09:53:51.982Z Has data issue: false hasContentIssue false

Spectroscopic Ellipsometry Study of HgCdTe Epilayer Surfaces During Electron Cyclotron Resonance Plasma Etching

Published online by Cambridge University Press:  10 February 2011

J. N. Johnson
Affiliation:
E-OIR Measurements, Inc., Spotsylvania, VA 22553, jjohnson@nvl.army.mil
J. H. Dinan
Affiliation:
Night Vision and Electronic Sensors Directorate, Ft. Belvoir, VA 22060
K. M. Singley
Affiliation:
Night Vision and Electronic Sensors Directorate, Ft. Belvoir, VA 22060
M. Martinka
Affiliation:
Night Vision and Electronic Sensors Directorate, Ft. Belvoir, VA 22060
B. Johs
Affiliation:
J. A. Woollam Co., Inc., Lincoln, NE 68508
Get access

Abstract

Spectroscopie ellipsometry has been used to monitor optical characteristics of HgCdTe surfaces during plasma etching in an electron cyclotron resonance reactor. Commonly used process conditions were found to induce changes in the ellipsometric parameters Δ and φ. A model was constructed to account for these changes in terms of process-induced roughness and mercury depleted sub-surface layers An independent characterization of the near-surface region was earned out ex situ after etching using Auger spectroscopy and x-ray photoelectron spectroscopy. Plasma process parameters were varied to isolate their influence on surface conditions and a set of parameters is given for which changes are minimized.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable