Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T23:14:39.509Z Has data issue: false hasContentIssue false

Sputtering Induced Changes in Defect Morphology and Dopant Diffusion for Si Implanted GaAs: Influence of Ion Energy and Implant Temperature

Published online by Cambridge University Press:  21 February 2011

H.G. Robinson
Affiliation:
Department of Electrical Engineering, Stanford University, Stanford, CA 94305
C.C. Lee
Affiliation:
Department of Materials Science, Stanford University, Stanford, CA 94305
T.E. Haynes
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, TN 37831
E.L. Allen
Affiliation:
Department of Materials Engineering, San Jose State University, San Jose, CA 95192
M.D. Deal
Affiliation:
Department of Electrical Engineering, Stanford University, Stanford, CA 94305
K.S. Jones
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 32611
Get access

Abstract

Experimental observations of dopant diffusion and defect formation are reported as a function of ion energy and implant temperature in Si implanted GaAs. In higher energy implants (>100 keV), little or no diffusion occurs, while at energies less than 100 keV, the amount of dopant redistribution is inversely proportional to energy. The extended defect density shows the opposite trend, increasing with increasing ion energy. Similarly, the diffusion of Si during post implant annealing decreases by a factor of 2.5 as the implant temperature increases from -2 to 40°C. In this same temperature range, the maximum depth and density of extrinsic dislocation loops increases by factors of 3 and 4, respectively. Rutherford Backscattering (RBS) channeling measurements indicate that Si implanted GaAs undergoes an amorphous to crystalline transition at Si implant temperatures between -51 and 40°C. A unified explanation of the effects of ion energy and implant temperature on both diffusion and dislocation formation is proposed based on the known differences in sputter yields between low and high energy ions and crystalline and amorphous semiconductors. The model assumes that the sputter yield is enhanced at low implant energies and by amorphization, thus increasing the excess vacancy concentration. Estimates of excess vacancy concentration are obtained by simulations of the diffusion profiles and are quantitatively consistent with a realistic sputter yield enhancement. Removal of the vacancy rich surface by etching prior to annealing completely suppresses the Si diffusion and increases the dislocation density, lending further experimental support to the model.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable