Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T00:31:51.737Z Has data issue: false hasContentIssue false

Sputtering of Molecules From ZnS, CdS, and FeS2

Published online by Cambridge University Press:  26 February 2011

S. Nikzad
Affiliation:
Department of Applied Physics, Caltech, Pasadena, CA 91125
W. F. Calaway
Affiliation:
Materials Science, Chemistry, and Chemical Technology Divisions, Argonne National Laboratory, Argonne, IL 60439, and T.A. Tombrello, Division of Physics, Mathematics, and Astronomy, Caltech, Pasadena, CA 91125
M. J. Pellin
Affiliation:
Materials Science, Chemistry, and Chemical Technology Divisions, Argonne National Laboratory, Argonne, IL 60439, and T.A. Tombrello, Division of Physics, Mathematics, and Astronomy, Caltech, Pasadena, CA 91125
C. E. Young
Affiliation:
Materials Science, Chemistry, and Chemical Technology Divisions, Argonne National Laboratory, Argonne, IL 60439, and T.A. Tombrello, Division of Physics, Mathematics, and Astronomy, Caltech, Pasadena, CA 91125
D. M. Gruen
Affiliation:
Materials Science, Chemistry, and Chemical Technology Divisions, Argonne National Laboratory, Argonne, IL 60439, and T.A. Tombrello, Division of Physics, Mathematics, and Astronomy, Caltech, Pasadena, CA 91125
Get access

Extract

It has been the general consensus in the sputtering community that molecules are sputtered from a clean metal surface in much smaller quantities than atoms. Some of the existing models further suggest that the sputter yield of molecules should be even lower from a compound than from a pure metal when the constituents of the molecule do not reside on neighboring sites in the solid.

In our experiments, neutral species sputtered from single crystals of ZnS, CdS, and FeS2 by a 3 keV Ar+ beam have been observed by laser photo-ionization followed by time-of-flight mass spectrometry. While the atomic metal (Fe, Zn, Cd) and S2 were the predominant species observed, substantial amounts of S, FeS, Zn2, ZnS, Cd2, and CdS were also detected. The experimental results demonstrate that molecules represent a larger fraction of the sputtered yield than was previously believed from secondary ion mass spectrometry experiments. In addition, our data suggest that the sputtered molecules are not necessarily formed from adjacent atoms in the solid. The applicability of various sputtering models will be discussed in the light of these results.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable