Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-15T02:19:56.801Z Has data issue: false hasContentIssue false

Stress Development in Low Dielectric Constant Silica Films During Drying and Heating Process

Published online by Cambridge University Press:  10 February 2011

Mengcheng Lu
Affiliation:
Advanced Materials Laboratory, Sandia National Laboratories and the University of New Mexico/NSF Center for Micro-Engineering Materials, 1001 University Blvd. SE, Albuquerque, NM 87106, lumc @unm.edu
C. Jeffrey Brinker
Affiliation:
Advanced Materials Laboratory, Sandia National Laboratories and the University of New Mexico/NSF Center for Micro-Engineering Materials, 1001 University Blvd. SE, Albuquerque, NM 87106, lumc @unm.eduSandia National Lab, Albuquerque, NM 87185, cjbrink@sandia.gov
Get access

Abstract

Low dielectric constant silica films are made using a surfactant templated sol-gel process (K∼2.5) or an ambient temperature and pressure aerogel process (K∼1.5). This paper will present the in-situ measurement and analysis of stress development during the making of these films, from the onset of drying till the end of heating. The drying stress is measured by a cantilever beam technique; the thermal stress is measured by monitoring the wafer curvature using a laser deflection method. During the course of drying, the surfactant templated films experience a low drying stress due to the influence of the surfactant on surface tension and extent of siloxane condensation. The aerogel films first develop a biaxial tensile stress due to solidification and initial drying. At the final stage of drying where the drying stress vanishes, dilation of the film recreates the porosity of the wet gel state, reducing the residual stress to zero. For the surfactant templated films, very small residual tensile stress remains after the heat treatment is finished (∼30MPa). Aerogel film has almost no measurable stress developed in the calcination process. In situ spectroscopic ellipsometry analysis during drying and heating, and TGA/DTA are all used to help understand the stress development.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable